Job Search:
 
job board -- all
job board -- jobs only
job board -- add a post
           home >> aerospace >> job board >> post


 

Structures Technician / Mechanic


Notice: Undefined index: HTTP_REFERER in /var/www/vhosts/roadtechs.com/httpdocs/aero/wwwboard/getpost.php on line 173 [ Back ] [ The Roadtechs Aerospace Job Board ] [ FAQ ] [Edit ] [Mark Position Closed ]

Posted by: Elwood Tradesmen <alex.minero@elwoodtradesmen.com> on May 29, 2017 at 00:04:01. Click here to reply to this post via Email.Click here for help with email link

Contract / Temp to Direct / Direct Hire: Direct Hire
City: Hawthorne
State: California
Country: United States
Zip or Postal Code: 90250
Reply to Recruiter via Text Msg: 6197722935

STRUCTURES TECHNICIAN/MECHANIC

RESPONSIBILITIES:

-Modification, repair, assembly, and installation of the rocket and spacecraft.
-Use tooling holes, pilot holes, or by hand (as required), per drawing or tooling instructions.
-Align parts and secure in place using clecos or tooling/hand clamps.
-Check for good edge margins and alignment.
-Shim and/or trim parts as required.
-Select drill bits, reamers and/or countersinking tools for pilot and full size holes.
-Locate, drill pilot holes using drill motor and proper size drill bit(s).
-Drill, ream, countersink full size holes in parts/assemblies, in proper sequence and to correct size using drill motor.
-Set countersinking tools to proper depth as required.
-Disassemble parts and deburr holes using chip chasers, deburring tools, and files to prepare for installation of fasteners.
-Use solvents to clean surfaces prior to sealing or assembly.
-Apply sealant, alodine, primer, adhesives, special finishes. Load and unload ovens to bond detail parts to assemblies
-Handle and dispose of hazardous materials in approved manner.
-Determine and obtain correct type and size fasteners.
-Cold work holes to prepare for close tolerance fastener installation.
-Install bushings into housings using arbor press and/or hydraulic puller.
-Apply liquid nitrogen to facilitate installation of bushings.
-Install fasteners in correct sequence per drawing, using correct tools (e.g., rivet gun and bucking bar, drill motor, power screwdriver, C-squeeze, ratchet wrench, nut runner).
-Check work after completion of each operation in job and/or completed job to ensure it is complete per drawing.
-Assembly of electrical harnesses
-Assembly of actuators
-Integration of components on electrical boards
-Work with electronic and mechanical assemblies

Pay: DOE $25-$35/per hour






      

187 page view(s)



Thinking about applying for this position?
Please make sure that you meet the minimum requirements indicated for the job before you apply (see user agreement). If you are qualified, then use either the email link (near top of post) or the application link (near bottom of post) to apply, whichever is provided.


Notice: Undefined index: HTTP_REFERER in /var/www/vhosts/roadtechs.com/httpdocs/aero/wwwboard/getpost.php on line 260
[ Back ] [ The Roadtechs Aerospace Job Board ] [ FAQ ] [Edit ] [Mark Position Closed ]

© Copyright - Roadtechs®, LLC. All rights reserved. No reproduction of any part of this website may be sold or
distributed for commercial gain nor shall it be modified or incorporated in any other work, publication, or website.
Use of this site implies compliance with the Roadtechs User Agreement.