Job Search:
 
job board -- all
job board -- jobs only
job board -- add a post
           home >> aerospace >> job board >> post


 

Reliability Engineer


Posted by: NESC <rgilbert@nesc.com> on August 21, 2017 at 00:04:01. Click here to reply to this post via Email.Click here for help with email link

Contract / Temp to Direct / Direct Hire: Contract
State: Iowa
Country: United States

Description:
This engineer will be responsible for providing R&M support to new development programs, including reliability and maintainability predictions and analyses, testability analyses, maintainability demonstrations, and highly accelerated stress testing.
Initially, this R&M engineer would be dedicated to performing testability analysis tasks. The objective of a testability analysis (TA) is to verify the equipment’s specified testability requirements, support maintainability repair time predictions (e.g., MTTR, MmaxTR), support FMEA/FMECA failure detection method identification, and support BIT or Maintainability Demonstration, if required, and to provide diagnostics information for use by the customer and RC internal users. The TA systematically identifies, evaluates, and documents the equipment’s functions, failure modes, method of failure detection and isolation, including a detailed test list and test oriented functional block diagram (FBD), in order to determine the effects of failures on mission and maintenance and to develop the equipment’s test design to optimize mission success, system performance, maintainability, and maintenance requirements.

Requirements:
- Prior experience in the area of reliability predictions and FMEA/FMECA.
- Prior experience with maintainability analysis and predictions.
- Built-in test experience.
- Knowledge of MIL-HDBK-217 reliability standards.
- Basic circuit analysis knowledge, HALT and RET experience.
- Bachelor's degree in Electrical Engineering or applicable field.







      

28 page view(s)



Thinking about applying for this position?
Please make sure that you meet the minimum requirements indicated for the job before you apply (see user agreement). If you are qualified, then use either the email link (near top of post) or the application link (near bottom of post) to apply, whichever is provided.


[ Back ] [ The Roadtechs Aerospace Job Board ] [ FAQ ] [Edit ] [Mark Position Closed ]

© Copyright - Roadtechs®, LLC. All rights reserved. No reproduction of any part of this website may be sold or
distributed for commercial gain nor shall it be modified or incorporated in any other work, publication, or website.
Use of this site implies compliance with the Roadtechs User Agreement.