Job Search:
job board -- all
job board -- jobs only
job board -- add a post
           home >> general construction >> job board >> post


[Rigger] Needing Riggers

Posted by: Roaddog Industrial <> on January 15, 2017 at 00:04:01. Click here to reply to this post via Email.Click here for help with email link

Contract / Temp to Direct / Direct Hire: Contract

Needing Riggers must have the following tools:
Stick Welder System
Gas Cutting Torch System
Electric Dram
Nail Claw 80mm, 500mm
Nylon Wire
Pipe Wrench 500m,300mm
Eye Bolt M8, M10, M12, M16, M20, M48
Lever Block 0.75 Ton, 1.5 Ton
Oil Pressure Jack & Hand Pump & Electrical Pump
4lb Sledge Hammer
10lb Sledge Hammer
Hexagon Wrench Set
Allen Wrench Set
Jig for Tightening Bolt
Single-Ended Spanner or Box Wrench
Adjustable Wrench
Aluminum Stepladder
Air Straight Grinder
Hose for Air
Lubricating oil (Grease is acceptable)
Powder Fire Extinguisher
Liquid Nitrogen and its Container


155 page view(s)

Thinking about applying for this position?
Please make sure that you meet the minimum requirements indicated for the job before you apply (see user agreement). If you are qualified, then use either the email link (near top of post) or the application link (near bottom of post) to apply, whichever is provided.

[ Back ] [ The Roadtechs General Construction Job Board ] [ FAQ ] [Edit ] [Mark Position Closed ]

© Copyright - Roadtechs®, LLC. All rights reserved. No reproduction of any part of this website may be sold or
distributed for commercial gain nor shall it be modified or incorporated in any other work, publication, or website.
Use of this site implies compliance with the Roadtechs User Agreement.