Outside Millwright Supervisor needed for a project in Charleston, SC!

� Pay $27 - $30 hr
� Per Diem: $79 working days / $59.25 travel days - in/out
� Duration: 14 days
� Accommodations: Air Travel, Hotel, and Rental car provided (if needed)
� Shift: Days - 7/10s
� Work will be performed on Two Propulsion Motors in the engine room of a ship (will be docked)
� Work to be completed: Inspect, replace bearings, and clean the propulsion motors.

Required:
� Must pass a Federal background check due to site access requirements
� Must pass a drug test
� 5+ years of motor or generator repair work and bearing removal/installation experience
� Experience working with 5000 HP motors

Scope of work:
� Oversee and inspect the work completed by workers assigned to you
� Inspect all dissembled and reinstallation of all removed bearings and motor parts
� Drain and dispose of any liquid in accordance with all local, state, and federal laws.
� Disassemble and temporarily remove bearings and inspect.
� Measure and record motor shaft axial clearances, runout, and air gap readings.
� Clean, stone, and polish the commutators, undercut rake, and chamfer the slots to refurbish them
to their original design condition.
� Disassemble and remove all division plates, baffles, and external components to allow cleaning
access to all windings and internal components.
� Assistance with removing and installing coupling bolts and covers etc., moving the stator back
and forth, and pole removal and installation.
� Work within tight tolerances and clearances