Job Search:
 
job board -- all
job board -- jobs only
job board -- add a post
           home >> manufacturing >> job board >> post


 

[Machinist] Machinist


Posted by: Aerotek <mopresley@aerotek.com> on October 10, 2018 at 10:28:34. Click here to reply to this post via Email.Click here for help with email link

Contract / Temp to Direct / Direct Hire: Contract
City: Lakeland
State: Florida
Country: United States

Minimum of 3 years experience on manual equipment (lathe, mill, drill) or 5 years of CNC machining experience (equipment list below)
Ability to perform required set up process.
Ability to perform duties with minimal supervision.
Ability to work from detailed prints and drawings as well as verbal instruction
Ability to use shop arithmetic including decimals and fractions.
Machinist Opportunity!
Requirements:
Ability to use judgment to perform and make decisions as to the sequence of setups, operations, and processes within the limitations of recognized or standard methods and procedures.
Must have basic tools of trade.(basic tools, veneer, micrometer)
*Knowledge of manual and CNC equipment processes
*Advanced knowledge of blueprints and layout work.
*CNC programming knowledge and experience (basic editing of codes) is preferred.
Pay: 22/hr
Shift: 1st shift: 7am-3pm + Overtime!






      

54 page view(s)



Thinking about applying for this position?
Please make sure that you meet the minimum requirements indicated for the job before you apply (see user agreement). If you are qualified, then use either the email link (near top of post) or the application link (near bottom of post) to apply, whichever is provided.



[ Back ] [ The Roadtechs Manufacturing Job Board ] [ FAQ ] [Edit ] [Mark Position Closed ]

© Copyright - Roadtechs®, LLC. All rights reserved. No reproduction of any part of this website may be sold or
distributed for commercial gain nor shall it be modified or incorporated in any other work, publication, or website.
Use of this site implies compliance with the Roadtechs User Agreement.