Duties and Responsibilities
Provide 2D/3D Structural Design staff augmentation support to SRNS. Primary responsibilities include design development, and generation of design output documents including but not limited to:
� Concrete buildings and foundations
� Structural steel for supports, platforms, and buildings
� Rebar detailing
� Steel detailing
� Preparation of fabrication drawings
� Review of vendor documents
� Commodity supports

Design services shall be provided using SRNS processes and procedures. Programmatic guidance will be provided by SRNS.

Education
An associates degree in a technical discipline and at least 10 - 12 years work experience or 12 - 16 years of practical work experience.
Position Specific: No additional requirements.

Experience/Skills
Requires an in-depth knowledge of engineering systems, applications, calculations, materials, construction methods, and relevant computer applications. Applies advanced principles and practices in engineering to resolve problems identified by construction organizations in a timely manner. Continued updating on new technologies and hardware in the industry is necessary.

Candidate must demonstrate 8 years of experience as a Structural Designer including experience with structural detailing and design of building structures and commodity supports. Knowledge of 3D structural modeling and experience using 3D Modeling using Hexagon�s S3D soſtware is required. Must have working knowledge of National Codes and Standards for structural design.

Candidate must be able to perform field walk-downs of the job site for the engineering work being performed. These walk-downs may involve construction sites with uneven surfaces and work in progress, walking for distances over a half mile, climbing ladders to access remote areas, dressing out in protective clothing.

Candidate must have the ability to produce quality documents with attention to detail.

OTHER REQUIRED QUALIFICATIONS
Area Security Access: Candidate must be able to obtain and maintain a DOE �Q� security clearance. An active DOE clearance is not initially required to perform assigned duties. After award, the selected candidate will be notified when to apply for a clearance based on specific work assignments.

Subcontractor must have an active eFOCI registration and approved Facility Level Clearance with DOE / NNSA.

PREFERRED QUALIFICATIONS
Possession of an active DOE clearance (L or Q) within the past two (2) years is preferred. Previous SRS Design Engineering or DOE facility experience is preferred.