Duties and Responsibilities
Develop designs for complex engineering systems. Prepare drawings and technical reports. Participate in the development of design standards and procedures. Perform technical review of design documents and specifications. Provide engineering services and support to construction activities.

Prepare and review design standards and procedures. Prepare construction installation specifications and details. Prepare procurement specifications and bid analysis. Review and approve Design Change Forms. Resolve existing design discrepancies with the most cost-effective approach to meet design criteria. Initiate Design Change Forms and coordinate with Subcontractors or other responsible group for approval/incorporation. Provide dispositions to Nonconformance Reports and Field Problem Memos by determining a solution to the condition which will satisfy design criteria. Perform inspections by facilities, systems, or components as required for proper evaluation of conditions. Review construction procedures to ensure compliance with design engineering criteria and applicable codes. Perform in-depth
analyses of advanced technical concepts and devises new approaches to technical problems.

Provide 2D-Microstation and 3D-S3D Electrical Designer staff augmentation
support to SRNS. Primary responsibilities include engineering analysis; 2D drawing
development utilizing MicroStation and 3D Modeling using Hexagon’s S3D software;
design development, and generation of design output documents

Prepare, review, and approve design change forms, disposition nonconformance
reports, review vendor documents and incorporate into 2D drawings and 3D
models, and resolve construction issues.

Education
An associate’s degree in technical discipline and at least 10 - 12 years’ work experience or 12- 16 years of practical work experience.

Experience/Skills
•Candidate must demonstrate 10 years work experience as an Electrical
Designer, including experience with Equipment Layout, Grounding, Raceway
Layout, Lighting Systems, and Schematics, Connection and Wiring Diagrams.
•Significant experience using 2D-Microstation and Hexagon’s S3D software, is
required.
•Candidate must demonstrate working knowledge of National Census Codes and
Standards for electrical design such as IEC, NEC, NFPA, NEMA, IEEE, and OSHA.

The following experience/skills/qualifications are preferred for this position:
•Previous SRS Design Engineering or DOE facility experience.
•Possession of an active DOE clearance (L or Q) within the past two (2) years
is preferred.

Additional Work Requirements
•Candidate must have the ability to produce quality documents with attention to
detail.
•Candidate must be able to perform weekly field walk downs of the job site for the
engineering work being performed. These walk downs may involve construction
sites with uneven surfaces and work in progress, walking for distances of over half a
mile, climbing ladders to access remote areas, and dressing out in protective
clothing