NAES Staffing Services is looking for an experienced, hands-on, and solution-driven Machinist to work an oil-fired, fossil fuel power station is Hawaii.

The machinist will assist with a Mitsubishi overhaul for 3 weeks in 2027. Actual dates TBD but will fall between 1/4/2026 - 3/20/2026. The daily per diem rate is $507. Pay rate is $50/hr.

Below are the machinist responsibilities needed during our overhaul.

PUMP REBUILDS:
A: Centrifugal pumps
B: Vane pump
C: Impeller pumps
D: Gear pump
E: Boiler feed water pumps

ALIGNMENTS
A: Motors to pumps
B: Fan alignment using belts, align sheeves.
C: Angle drive rebuild and align
D: Generator/ excitor alignment measuring air gap. Shims to adjust
E: Alignments done with rev-align or reverse alignment
F: Using single or dual dial gauges

MACHINES
A: Lathes
B: Milling machine
C: Post grinder for valves, valve cages, and lapping tools.
D: Chris Marine surface grinder. Machining liner, supports, and deck.

MISC. MACHINIST RESPONSIBILITES
A: Dowels taper and straight
B: Drill and ream for dowel fitting.
C: Electric motor end bells; measure, re-sleeve, and machine down to fit bearings.
D: Lube oil purifiers and strainers.