home >> general construction >> job board >> post





Heavy Equipment Shop Technician

[ Back ] [ The Roadtechs General Construction Job Board ] [ Help ] [Edit ] [Mark Position Closed ]

Posted by: Carolina CAT <eblackmon@carolinacat.com> on April 01, 2019 at 00:04:01. Click here to reply to this post via Email.Click here for help with email link

Post Number: 518644
Posted By: Carolina CAT
Posted On: 2019-04-01 00:04:01
Email Address: eblackmon@carolinacat.com
Subject: Heavy Equipment Shop Technician
Contract / Temp to Direct / Direct Hire: Direct Hire
City: Charlotte
State: North Carolina
Country: United States
Zip or Postal Code: 28269

Summary

The primary function of this position is to troubleshoot, remove, install, replace, re-build, repair, & test parts/equipment on construction equipment.

Essential Duties and Responsibilities include the following. Other duties may be assigned.
•The employee uses miscellaneous resources and computers to reference parts, get information about parts & enter data into record systems.
•The employee uses tools to disassemble/re assemble parts or equipment; cleans parts with rags, cleaners, power washer; uses test equipment to make diagnostic checks; and controls powered equipment or tools to make repairs.
•The employee climbs up onto, under, & into vehicles to gain access to all parts of vehicle.
•The employee uses overhead hoists, lift devices, forklifts & other aides to move items off vehicle (tracks, idler wheels, blades, etc.) & then to move parts to locations for disassembly, repair, then back to the vehicle for reassembly.
•The employee will do inspections, do preventative maintenance, change oil, replace filters, belts, coolants, hoses, may drain/clean/refill fuel systems.
•The employee will use welders to weld frames, wear strips then use power grinders to grind welds smooth.
•The employee will lift/carry and position ram used to remove idlers, unbolt idlers, remove them with overhead crane.
•The employee uses power washers & spray paint equipment to clean & paint vehicle.
•The employee will use instruments and computers to reprogram equipment controllers.


Education and/or Experience
•High school diploma/certificate or equivalent.
•3-5 years of related experience.
•Ability to read, write, speak and understand the local language, reads and comprehends technical data/service manuals and writes legibly.
•Ability to lift a minimum of 70 pounds.
•Ability to stand for extended periods of time, perform repetitive bending tasks and achieve required torque specifications per manufacturer's repair procedures.

Location: Charlotte, NC



Thinking about applying for this position?
Please make sure that you meet the minimum requirements indicated for the job before you apply (see user agreement). If you are qualified, then use either the email link (near top of post) or the application link (near bottom of post) to apply, whichever is provided.


[ Back ] [ The Roadtechs General Construction Job Board ] [ Help ] [Edit ] [Mark Position Closed ]


59 page view(s)

© Copyright - Roadtechs®, LLC. All rights reserved. No reproduction of any part of this website may be sold or
distributed for commercial gain nor shall it be modified or incorporated in any other work, publication, or website.
Use of this site implies compliance with the Roadtechs User Agreement.